Propresenter 6 mac forum5/15/2023 I used Syphon to transfer the video data and loopback to transfer audio. I had three MimoLive instances running at the same time, one for streaming and recording (which wasn’t performing to our expectations), one for visuals, and one for the television. This requires a separate mix that I tried to achieve by using MimoLive in creative ways. A lot of our clients like to have a television behind them in the set, displaying a logo, slides, video playback etc. In the meantime, there was another problem to overcome, namely video playback on a television in the studio. To be fair, it did the job, but with loads of dropouts, mainly during recording. This means the bandwith of the data is quite high, and the M1 was not capable enough of both streaming and recording simultaneously. All our productions are set to 1080p 50fps, mainly because I don’t like to use a lot of deinterlacers. I used MimoLive on that Mac Mini to solely stream and record by using an UltraStudio Mini Recorder 3G. Therefore, I purchased a new Mac Mini M1 (I mean what’s the point of purchasing a more expensive Intel Mac Mini). I make use of a lot of automations and API connections, which kind of scares me. Suddenly it seemed I was doing a lot of processing on one computer. This also gave me some extra outputs to utilize. Since I use a Mac Mini (2018, Sonnet RackMac enclosure), I needed a boost in graphic performance and thus I used Sonnet’s eGFX in combination with the VEGA56 graphics card. BlackMagic claims it is impossible to use SDI playout and capture simultaneously, but it works perfectly fine. The program output of the ATEM was then again routed into the UltraStudio HD Mini and used as an input source in another MimoLive session. It’s great to have your visuals on the multiview, especially when you use an image director. I used MimoLive to generate all our media content and displaying it via the UltraStudio HD Mini by generating SDI playout (fill & key). After purchasing an ATEM Mini Television Studio HD and an UltraStudio HD Mini, I came up with the following setup.
0 Comments
Leave a Reply. |